H. Electrical Component Inspection 电气组件检查 CAUTION: REFER TO APPLICABLE MANUAL PRIOR TO PERFORMING ANY ELECTRICAL CHECKS TO ENSURE THAT CHECKS WILL NOT DAMAGE EQUIPMENT. 注意...

INTRODUCTION介绍 1. General 通用 Information provided in this manual pertains to overhaul and repair processing for parts manufactured by Honeywell Inc., Phoenix, Arizona. 本手册提...

E. Bearing Inspection 轴承检查 (1) Separable Bearings: 可分解的轴承。 Table 301. Separable Bearing Defect Definitions 表301 可分解轴承缺陷的定义 Term 项目 Definition (Description o...

G. Visual Inspection 目视检查 (1) General Information 通用信息 (a) Visual inspection involves viewing the part for general appearance in an effort to locate conditions, which cause...

SECTION I – DISASSEMBLY分解 TABLE OF CONTENTS 目录 SECTION 章节 1. Standard Disassembly Practices 标准分解操作 A. General 通用 B. Identification of Matched Parts and Sets 识别配合...

3. Standard Cleaning Methods 标准清洁方法 CAUTION: SPECIFIED CLEANING METHODS OUTLINED MUST BE FOLLOWED. THE VARIOUS SOLUTIONS AND MATERIALS SPECIFIED IN THE CLEANING METHODS CAN B...

2. Preparation of Cleaning Solutions 清洁溶液的配制 WARNING: SOLUTIONS USED FOR CLEANING ARE HAZARDOUS. AVOID INHALING FUMES, DUST, OR MIST. AVOID CONTACT WITH SKIN. AFTER PREPARAT...

SECTION III – INSPECTION第三章 – 检查 TABLE OF CONTENTS 目录 SECTION 章节 1. Standard Inspection Practices 标准检查施工 A. General 通用 B. General Inspection Procedures 通用检查...

F. Gear and Spline Inspection 齿轮和花键检查 (1) Check gear and spline teeth as follows: 检查齿轮和花键齿，如下所示： (a) Perform visual check using a strong light and a minimum of...

TABLE OF CONTENTS 目录 SECTION 章节 1. Standard Cleaning Practices 标准清洁规范 A. General 通用 2. Preparation of Cleaning Solutions 清洁溶液的配制 A. Method No. 202A: Alkaline Cle...