飞机维修工程管理-持续适航文件
一、持续适航文件(ICA)的定义FAA Order 8110.54A中关于ICA的定义描述为:“Instructions for Continued Airworthiness (ICA).Documentation that gives instructions and requirements for the m...
SECTION IV – REPAIR 15-修理损坏/超尺寸螺纹
15. Repairing Damaged/Oversize Threads 修理损坏/超尺寸螺纹 NOTE: Refer to Method No. 407A, 407B, and 407C for repair of loose or damaged inserts. Prepare for and install standard H...
SOPM20-30-94应用防雨侵蚀涂料前进行最终清洗的溶剂（94系列）
应用防雨侵蚀涂料前进行最终清洗的溶剂（94系列）SOLVENTS FOR FINAL CLEANING BEFORE APPLICATION OF RAIN EROSION RESISTANT COATINGS (SERIES 94) 1. GENERAL 通用 A. Thissubject contai...
SECTION IV – REPAIR 修理（三）-J.Method No. 403J: Selective Electroplating
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用J.Method No. 403J: Selective ElectroplatingMethod No. 403J:选择性电镀NOTE: If parts out of ap...
SECTION III – INSPECTION 1. Standard Inspection Practices -I.弧形联轴器检查
I.Curvic Coupling Inspection 弧形联轴器检查NOTE: Nomenclature for curvic coupling is provided in Figure 320.注：图 320 中提供了弧形联轴器的命名。(1) Inspect components with curvic ...
bolt、screw、nut、washer……
紧固件分类：永久型和可拆卸型永久型紧固件在从飞机上拆除时需要破坏其部分或全部结构，例如铆钉、锁螺栓或高锁螺栓。可拆卸型紧固件则包括疲劳螺栓或结构螺栓。1. Bolt（螺栓／结构螺栓／Hi-Lo...
SOPM20-50-16压接钢索的组装
压接钢索的组装ASSEMBLY OF SWAGED CABLES 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5002. Access to the Boeing Process Specification...
SECTION IV – REPAIR 5.清除钢制零件上的损伤-C.Method No. 405C: 使用玻璃珠喷丸修复密封直径（唇形密封面）
5.Removing Damage from Steel Parts清除钢制零件上的损伤C.Method No. 405C: Seal Diameter (Lip Seal Surface) Repair Using Glass Bead PeeningMethod No. 405C: 使用玻璃珠喷丸修复密封直径...
SECTION IV – ASSEMBLY 5 -扭矩要求
5. Torque Requirements 扭矩要求 Torque requirements for air, oil and fuel system components depend on the type of parts being fastened or tightened. 空气、滑油及燃油系统组件的扭矩...
SECTION IV – REPAIR 8-齿轮齿修复-A.Method No. 408A:齿轮齿渐开线表面轻微损伤修复
8. Repairing Gear Teeth齿轮齿修复A.Method No. 408A: Minor Gear Teeth Involute Surface Damage RepairMethod No. 408A:齿轮齿渐开线表面轻微损伤修复Repair minor surface damage on gear t...
SOPM20-44-03聚氨酯抗雨侵蚀涂层的应用
聚氨酯抗雨侵蚀涂层的应用APPLICATION OF POLYURETHANE RAIN EROSION RESISTANT COATING 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC58...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-C.Method No.403C：薄而致密的镀铬零件修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用C.Method No. 403C: Thin Dense Chrome Plated Parts RepairMethod No.403C：薄而致密的镀铬零件修...
飞机维修工程管理-波音737NG飞机持续适航文件介绍（一）
一、波音737NG飞机持续适航文件访问方法正常访问波音737NG飞机持续适航文件需要有波音网账号，运营波音公司飞机的运营人只要与波音签署的CSGTA，并缴纳一定的年费或通过购买飞机/其他软件(如m...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-D.Method No.403D：金属喷涂修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用D.Method No. 403D: Metal Spray RepairMethod No.403D：金属喷涂修复NOTE: Electric Arc Spray and...
SECTION VI – PACKAGING – 包装（完）
SECTION VI - PACKAGING包装 1.General概述Refer to applicable manual for unit in work for general packaging procedures. For APUs, refer to Service Bulletin 49-7997 for Preservation ...
SECTION III – INSPECTION 1. Standard Inspection Practices -O.设备和材料
O.Equipment and Materials设备和材料Table 309 lists equipment and materials that may be required for inspection. Equivalent equipment and materials may be substituted for them.表309...
Honeywell-STORAGE存储
存储（含运输）STORAGE (INCLUDING TRANSPORTATION) 1. Planning Data 计划数据 A. Reason for the Job 工作原因 (1) Use these procedures to prepare the modulating shutoff valve for stora...
SECTION III – INSPECTION 1. Standard Inspection Practices -E. 轴承检查
E. Bearing Inspection轴承检查(1) Separable Bearings:可分解的轴承。Table 301. Separable Bearing Defect Definitions表301 可分解轴承缺陷的定义Term项目Definition (Description of Defect...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-K.Method No. 403K:修复受损的油漆涂层-环氧胺体系
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用K.Method No. 403K: Repair of Damaged Paint Coatings - Epoxy-Amine SystemsMethod No. 403K:修复...
