张群
737NG-ATA 52 门【系统原理】
目录1．介绍2．标准门封严3．登机门1）介绍2）装饰板和隔垫3）手柄机构4）导轨、锁和止动装置5）前登机门扭力管6）后登机门扭力管7）前登机门上铰链组件8）后登机门上铰链组件8）后登机门上铰链...
SOPM20-30-83复合材料一般清洗用溶剂（83系列）
复合材料一般清洗用溶剂（83系列）SOLVENTS FOR GENERAL CLEANING OF COMPOSITES (SERIES 83) 1. GENERAL 通用 A. This subject contains a list of solvents for general cleaning of c...
SECTION IV – ASSEMBLY 5 -扭矩要求
5. Torque Requirements 扭矩要求 Torque requirements for air, oil and fuel system components depend on the type of parts being fastened or tightened. 空气、滑油及燃油系统组件的扭矩...
SECTION IV – REPAIR 11-焊接零件修理
Repairing Welded Parts 焊接零件修理 NOTE: Refer to applicable manual for unit for specialized welding. 注：特殊焊接操作请参阅设备适用手册。 A. Method No. 411A: Fusion Weld Repair o...
SOPM20-41-04内部装饰饰面的应用
内部装饰饰面的应用APPLICATION OF INTERIOR DECORATIVE FINISHES 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5755. The airline ha...
SECTION IV – ASSEMBLY 4-压装过盈配合零件
4.Pressing Interference Fit Parts压装过盈配合零件CAUTION: DURING ASSEMBLY OF SOME UNITS, CLOSE TOLERANCE FITS REQUIRE THAT A PART WILL EITHER HAVE TO BE COLD SOAKED OR HEATED IN OR...
Honeywell-DISASSEMBLY分解
分解DISASSEMBLY 1. Planning Data 计划数据 A. Reason for the Job 工作原因 (1) Use these procedures to remove parts from the modulating shutoff valve to do the cleaning, checks, and ...
bolt、screw、nut、washer……
紧固件分类：永久型和可拆卸型永久型紧固件在从飞机上拆除时需要破坏其部分或全部结构，例如铆钉、锁螺栓或高锁螺栓。可拆卸型紧固件则包括疲劳螺栓或结构螺栓。1. Bolt（螺栓／结构螺栓／Hi-Lo...
SOPM20-42-07镀铜
镀铜COPPER PLATING 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5722. The airline has a copy of the Boeing Process Specificatio...
SOPM20-44-03聚氨酯抗雨侵蚀涂层的应用
聚氨酯抗雨侵蚀涂层的应用APPLICATION OF POLYURETHANE RAIN EROSION RESISTANT COATING 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC58...
SOPM20-44-04聚氨酯兼容底漆的应用
聚氨酯兼容底漆的应用APPLICATION OF URETHANE COMPATIBLE PRIMER 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5882. Access to the Boe...
