SECTION III – INSPECTION 1. Standard Inspection Practices -H. Electrical Component Inspection电气组件检查
H. Electrical Component Inspection 电气组件检查CAUTION: REFER TO APPLICABLE MANUAL PRIOR TO PERFORMING ANY ELECTRICAL CHECKS TO ENSURE THAT CHECKS WILL NOT DAMAGE EQUIPMENT.注意：...
SECTION IV – REPAIR 4. 修理铝制零件-D.Method No. 404D:燃油和滑油泵铝制壳体表面修复
4. Repairing Aluminum Parts 修理铝制零件D.Method No. 404D: Fuel and Oil Pump Aluminum Housing Surface RepairMethod No. 404D:燃油和滑油泵铝制壳体表面修复Repair worn and/or damaged s...
2780537 WING THERMAL ANTI-ICE PRESSURE REGULATING AND SHUTOFF VALVE ASSEMBLY
机翼热防冰压力调节和关断活门组件 一、名称 WING THERMAL ANTI-ICE PRESSURE REGULATING AND SHUTOFF VALVE ASSEMBLY 机翼热防冰压力调节和关断活门组件 二、件号 2780537-102~-104 三、章节号...
飞机上的密封件【转】
O型封圈上有标记点，白色或者其他颜色。这些标记点，具体的含义，可以从手册里查到吗？ 翻看执照书，书上有提及： 波音网站上查看封圈的厂家标准，显示这些标记只是代表不同厂家： ...
SECTION III – INSPECTION 检查（十）-复合材料部件
N.Composite Material Components 复合材料部件 (1) Check per Table 308. 按照表308进行检查。
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-C.Method No.403C：薄而致密的镀铬零件修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用C.Method No. 403C: Thin Dense Chrome Plated Parts RepairMethod No.403C：薄而致密的镀铬零件修...
航空开关知识和相关术语，switch，Microswitches，Relays
Switches 开关Switches control the current flow in most aircraft electrical circuits. A switch is used to start, to stop, or to change the direction of the current flow in the circu...
飞机飞行手册介绍 Introduction to AFM【转】
AFM 手册的批准和使用 Approval and Utilization of AFM 飞机飞行手册（Aircraft Flight Manual，AFM）是经过官方批准格式标准规范的指导手册。该文件既可作为培训辅助，也可以作为处理正常和非...
关于件号为6740G010000的OPV的维修提示
维修提示 MAINTENANCE TIPS背景及现象BACKGROUND OR PHENOMENON新引进B-303M和B-302Y两架飞机四个发动机引气系统有三个均出现“AIR ENG2 BLEED ABNORM PR”的警告信息，并伴有“OVPRESS-V 5HA2/...
SECTION IV – REPAIR 修理（三）-O. Method No. 403O: Chemical Film Touch-Up of Magnesium
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用O.Method No. 403O: Chemical Film Touch-Up of MagnesiumMethod No. 403O:镁的化学膜修补(1) Remov...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-N.Method No. 403N: 铝的化学膜修补
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用N.Method No. 403N: Chemical Film Touch-Up of AluminumMethod No. 403N: 铝的化学膜修补(1) Remov...
6740F010000,6740G010000 OVERPRESSURE VALVE
一、名称OVERPRESSURE VALVE超压活门二、件号6740F010000,6740G010000三、章节号36-11-12四、适用机型A320五、系统36 PNEUMATIC气源六、安装位置发动机短舱七、部件原理Operation Fig FUNC-3工...
飞机防冰系统-防冰部位和方法（Anti-icing Parts and Methods of Aircraft）【转】
飞机防冰系统-防冰部位和方法Aircraft Anti-icing System-Anti-icing Parts and Methods 飞机结冰会使飞机的空气动力性能变坏、发动机性能变坏、有关仪表读数不准，由此引起飞机的操纵性、稳定...
SECTION III – INSPECTION 检查（六）-弧形联轴器检查
I.Curvic Coupling Inspection 弧形联轴器检查NOTE: Nomenclature for curvic coupling is provided in Figure 320.注：图 320 中提供了弧形联轴器的命名。(1) Inspect components with curvic ...
SECTION IV – REPAIR 修理（三）-C.Method No. 403C: Thin Dense Chrome Plated Parts Repair
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用C.Method No. 403C: Thin Dense Chrome Plated Parts RepairMethod No.403C：薄而致密的镀铬零件修...
SECTION III – INSPECTION 1. Standard Inspection Practices -I.Curvic Coupling Inspection弧形联轴器检查
I.Curvic Coupling Inspection 弧形联轴器检查NOTE: Nomenclature for curvic coupling is provided in Figure 320.注：图 320 中提供了弧形联轴器的命名。(1) Inspect components with curvic ...
SECTION IV – REPAIR 4. 修理铝制零件-E.Method No. 404E:轻微腐蚀修复
4. Repairing Aluminum Parts 修理铝制零件E.Method No. 404E: Minor Corrosion RepairMethod No. 404E:轻微腐蚀修复Remove minor corrosion from aluminum-alloy parts as follows:按如下步骤...
2790583 COWL ANTI-ICE 3 1/2 INCH CONTROL VALVE ASSEMBLY
3-1/2英寸防冰控制活门组件 一、名称 COWL ANTI-ICE 3 1/2 INCH CONTROL VALVE ASSEMBLY 3-1/2英寸防冰控制活门组件 二、件号 2790583-104~-108,-105C,S312T001-4,-6,-7,-8 三、章节号 30-20-01...
Sealing Compounds
Sealing Compounds 密封化合物 Certain areas of all aircraft are sealed to withstand pressurization by air, to prevent leakage of fuel, to prevent passage of fumes, or to prevent cor...
SECTION III – INSPECTION 检查（十一）-设备和材料
O.Equipment and Materials设备和材料Table 309 lists equipment and materials that may be required for inspection. Equivalent equipment and materials may be substituted for them.表309...
