SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-O. Method No. 403O:镁的化学膜修补
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用O.Method No. 403O: Chemical Film Touch-Up of MagnesiumMethod No. 403O:镁的化学膜修补(1) Remov...
何为飞机的A检、B检、C检和D检？
飞机的A检、B检、C检和D检是根据飞行时间或起落次数对飞机进行的定期检查等级。A检：A检是最基础的检查，其飞行间隔通常较短，例如家用波音737的A检通常设置为200小时。A检不需要专门的飞行日停...
SECTION IV – ASSEMBLY 1-通用组装程序
1. General Assembly Practices 通用组装程序A. Protecting Unit During Assembly组装过程中的部件防护Maintain fits and clearances as specified in applicable manual for unit in work. Exe...
电气性能之绝缘电阻、介电强度、电阻、搭接电阻的介绍
电气性能之绝缘电阻、电阻、搭接电阻、介电强度 我们在做机械部件电气测试时，CMM要求测试的电气性能主要有：绝缘电阻、电阻、电连接、介电强度等，下面为大家简单讲解它们的具体的功能及区...
4020W35-2 RAIN REPELLENT GAGE ASSEMBLY【部件介绍】
防雨计组件4020W35-2 一、名称 RAIN REPELLENT GAGE ASSEMBLY 防雨计组件 二、件号 4020W35-2 三、章节号 30-45-10 四、适用机型 A320 五、系统 30 ICE AND RAIN PROTECTION 防冰防雨 六、安装...
AIR BLEED在A320CEO和A320NEO触发有啥不同？【转】
AIR BLEED维护信息在A320CEO和A320NEO触发在A320CEO和A320NEO触发有啥不同 事件背景 随着A320FAM飞机的更新换代，新一代的A320NEO飞机比A320CEO飞机有许多改进的地方，飞机的引气系统也不例外。...
341E030000 SOLENOID THERMOSTAT
SOLENOID THERMOSTAT 电磁恒温器一、名称SOLENOID THERMOSTAT电磁恒温器二、件号341D010000,341E010000,341E020000,341E030000,341E030000 AMDT A三、章节号36-11-43四、适用机型A320五、系统36...
SECTION III – INSPECTION 1. Standard Inspection Practices -I.弧形联轴器检查
I.Curvic Coupling Inspection 弧形联轴器检查NOTE: Nomenclature for curvic coupling is provided in Figure 320.注：图 320 中提供了弧形联轴器的命名。(1) Inspect components with curvic ...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-G.Method No. 403G:耐磨涂层表面磨损修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用G.Method No. 403G: Abradable Coating Surface Wear RepairMethod No. 403G:耐磨涂层表面磨损修复N...
SECTION IV – REPAIR 4. 修理铝制零件-E.Method No. 404E:轻微腐蚀修复
4. Repairing Aluminum Parts 修理铝制零件E.Method No. 404E: Minor Corrosion RepairMethod No. 404E:轻微腐蚀修复Remove minor corrosion from aluminum-alloy parts as follows:按如下步骤...
SECTION IV – REPAIR 7-更换钢丝螺套、螺柱、衬套、销钉和螺母板-H.Method No. 407H：松动、磨损或损坏的 Rosan螺柱和钢丝螺套的更换
7.Replacing Inserts, Studs, Bushings, Pins and Nutplates更换钢丝螺套、螺柱、衬套、销钉和螺母板H.Method No. 407H: Loose, Worn, or Damaged Rosan Stud and Insert ReplacementMethod No....
SOPM20-10-04镀铬零件的研磨
镀铬零件的研磨GRINDING OF CHROME PLATED PARTS 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5032. Access to the Boeing Process Specifi...
Torque and Torque Wrenches力矩和力矩扳手
Torque and Torque Wrenches力矩和力矩扳手 NOTE: The strongest threaded joint is one in which the load applied to the fastener when it is installed is greater than the maximum loa...
防火系统 Fire Protection System【转】
防火系统组成 Composition of Fire Protection System 飞机的防火系统由火警探测系统和灭火系统两大部分组成。防火系统平常不工作，一旦发生火险必须迅速扑灭火源，因此，飞机的防火系统需要定...
发动机的性能和适用范围 Engine Performance and Scope of Application【转】
发动机的性能主要表现在推力特性、燃油消耗特性。 The performance of the engine is mainly reflected in thrust characteristics and fuel consumption characteristics. （1）推力特性 Thrus...
SECTION III – INSPECTION 1. Standard Inspection Practices -G. 目视检查
G. Visual Inspection目视检查(1) General Information通用信息(a) Visual inspection involves viewing the part for general appearance in an effort to locate conditions, which cause or ...
SPM 20-90-01波音氧气系统部件清洁工艺(Cobham)
Cleaning Process for Boeing Oxygen System Components-Standard Practice Manual丨波音氧气系统部件清洁工艺-标准操作手册 TABLE OF CONTENTS CLEANING PROCESS 1. Scope 2. General Recommen...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-K.Method No. 403K:修复受损的油漆涂层-环氧胺体系
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用K.Method No. 403K: Repair of Damaged Paint Coatings - Epoxy-Amine SystemsMethod No. 403K:修复...
SECTION IV – REPAIR 6 -修理镁零件-C.Method No. 406C:镁合金零件的沟槽和划伤修复
6.Repairing Magnesium Parts修理镁零件C.Method No. 406C: Magnesium-Alloy Parts Gouge and Scoring RepairMethod No. 406C:镁合金零件的沟槽和划伤修复Repair minor damage to magnesium-all...
