6740E010000 OVERPRESSURE VALVE
一、名称OVERPRESSURE VALVE超压活门二、件号6740E010000,6740E010000 Amdt A三、章节号36-11-58四、适用机型A320五、系统36 PNEUMATIC气源六、安装位置发动机短舱七、部件原理General Descript...
A320neo-HPV failed in CLOSE position【转】
A320neo - HPV failed in CLOSE position Reference: 36.11.00.115 A320FAM neo - HPV failed in CLOSE position leading to HP VALVE FAULT or BLEED ABNORMAL PR Engineering Support Appl...
65E63 ANTI-ICING VALVE ASSEMBLY【部件介绍】
发动机防冰活门65E63 一、名称 ANTI-ICING VALVE ASSEMBLY 防冰活门组件 二、件号 65E63-2 三、章节号 30-21-11 四、适用机型 A330 五、系统 30 ICE AND RAIN PROTECTION 防冰防雨 六、安装位置...
飞机不得起飞的情况【转】
出现哪些情况飞机不得起飞？ Under what circumstances may the plane not take off? 有下列情况之一的，不得起飞： Aircraft are prohibited to take-off in any of the following circumstanc...
SECTION III – INSPECTION 检查（四）-目视检查Visual Inspection
G. Visual Inspection 目视检查 (1) General Information 通用信息 (a) Visual inspection involves viewing the part for general appearance in an effort to locate conditions, which cause...
SOPM20-10-03喷丸
喷丸SHOT PEENING 1. INTRODUCTION 介绍 A.The data in this subject comes from Boeing Process Specifications BAC5730, BAC5730-2 and BAC5951. Access to the Boeing Process Specificat...
SECTION IV – REPAIR 修理（三）-A.Method No. 403A: Anodized Aluminum and Aluminum-alloy Repair
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用A.Method No. 403A: Anodized Aluminum and Aluminum-alloy Repair方法403A：阳极氧化铝和铝合金修...
SECTION III – INSPECTION 1. Standard Inspection Practices -F. 齿轮和花键检查
F. Gear and Spline Inspection 齿轮和花键检查(1) Check gear and spline teeth as follows:检查齿轮和花键齿，如下所示：(a) Perform visual check using a strong light and a minimum of 5 ...
ANTI ICE ENG1（2） VALVE CLSD故障分析-CFM56
1.背景B-XXXX飞机监控到有ANTI ICE ENG1 VALVE CLSD信息，航后更换1发防冰活门，试车故障依旧；进一步检查发现防冰活门连接的SENSELINE有漏气，更换漏气的软管后，试车正常。2.原理CFM56发动机...
A320NEO机队（LEAP-1A）常见故障处置-HPV卡阻、失效【转】
A320NEO（LEAP-1A）HPV卡阻、失效 一 典型案例 2023年11月22日，B-30XX飞机06航段监控到HP BLEED-V (4000HA1)故障信息，机组反馈ECAM上无警告信息，BLEED页面上左发HPV活门显示关闭状态（巡...
Honeywell-DISASSEMBLY分解
分解DISASSEMBLY 1. Planning Data 计划数据 A. Reason for the Job 工作原因 (1) Use these procedures to remove parts from the modulating shutoff valve to do the cleaning, checks, and ...
航空发动机的种类-活塞式和喷气式发动机 Types of Aero-Engine-Piston and Jet Engines【转】
航空发动机为飞机提供飞行所需动力，民用主要有两种类型：活塞式发动机和喷气式发动机。 Aero-engines provide aircraft with the power required for flight. There are two main types of civ...
4404B-维护码：47-30025
一、基本信息1)件号：4404B000-0042)名称：Overtemperature shutoff valve (OTSOV)3)机型：737NG，B7774)章节号：47-11-01二、故障信息维护码：4730025
SECTION III – INSPECTION 检查（九）-用于电子设备校准和检查的热电偶模拟器
M.Thermocouple Simulators for Calibration and Checkout of Electronic Equipment 用于电子设备校准和检查的热电偶模拟器 (1) For test purposes in simulating a thermocouple, a common and...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-A.Method No. 403A: 阳极氧化铝和铝合金修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用A.Method No. 403A: Anodized Aluminum and Aluminum-alloy RepairMethod No. 403A: 阳极氧化铝和铝...
SECTION IV – REPAIR 6 -修理镁零件-A.Method No. 406A:轻微损坏修理
6.Repairing Magnesium Parts修理镁零件A.Method No. 406A: Minor Damage RepairMethod No. 406A:轻微损坏修理NOTE: Refer to Method No. 403L for repair of paint coatings for magnesium par...
ATA2200系统章节名称中英文对照
系统章节名称 ATA2200对各章进行了细分，其中，20-49 章为飞机系统，51-57 章为飞机结构，70-80章为发动机，没有定义的章留着备用。 除了章外，对节也进行了细分。以ATA 28...
A320-52舱门【系统原理】
空客 319/320 -52 章 舱门 舱门 一般介绍 舱门结构概述 紧急出口（A318/A319/A320） 货舱门 其他舱门介绍 指示与警告 一般介绍 概述 舱门系统 ——旅客舱门 ——客舱应急舱门 ——货舱门 —...
SOPM20-11-06缠绕导线电气连接的修理
缠绕导线电气连接的修理REPAIR OF WRAPPED WIRE ELECTRICAL CONNECTIONS 1. INTRODUCTION 介绍 A. A wrapped wire connection consists of a helix of continuous, solid, uninsulated wire ...
SOPM20-10-07钛的机械加工
钛的机械加工MACHINING OF TITANIUM 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5492, and Boeing Operators Handbook 6M59-553, 'Machini...
