飞机维修工程管理-审定维修要求(CMR)
审定维修要求（CMR）背景及定义：按照CCAR/FAR 25.1309要求，对运输类飞机的系统进行安全性分析和评估时，提出了故障探测要求，以防止危险性和灾难性故障发生。对这些要求经过进一步评审，被确...
107492 BLEED AIR REGULATOR【部件介绍】
引气调节器107492 一、名称 BLEED AIR REGULATOR 引气调节器BAR 二、件号 107492-1~-3,-5,-6,10-62008-10,-23,-37,-40,-41 三、章节号 36-13-95 四、适用机型 B737-300/-400/-500/-600/-700/-80...
HOEYWELL SECTION II – CLEANING 清洁（一）
TABLE OF CONTENTS 目录 SECTION 章节 1. Standard Cleaning Practices 标准清洁规范 A. General 通用 2. Preparation of Cleaning Solutions 清洁溶液的配制 A. Method No. 202A: Alkaline Cle...
飞机防冰系统-防冰部位和方法（Anti-icing Parts and Methods of Aircraft）【转】
飞机防冰系统-防冰部位和方法Aircraft Anti-icing System-Anti-icing Parts and Methods 飞机结冰会使飞机的空气动力性能变坏、发动机性能变坏、有关仪表读数不准，由此引起飞机的操纵性、稳定...
766A0000PNEUMATIC TEMPERATURE SENSOR
一、名称PNEUMATIC TEMPERATURE SENSOR气动温度传感器二、件号766A0000-01,766B0000-01,766C0000-01三、章节号21-52-28四、适用机型A318/A319/A320/A321/A330/A340五、系统21 AIR CONDITIONING...
SOPM20-10-01高强度钢零件的修理和表面处理
高强度钢零件的修理和表面处理REPAIR AND REFINISH OF HIGH STRENGTH STEEL PARTS 1. INTRODUCTION 介绍 A.The procedures in this subject are applicable to high strength, low-alloy steel ...
SECTION IV – REPAIR 修理（三）-D.Method No. 403D: Metal Spray Repair
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用D.Method No. 403D: Metal Spray RepairMethod No.403D：金属喷涂修复NOTE: Electric Arc Spray and...
SECTION III – INSPECTION 1. Standard Inspection Practices -I.Curvic Coupling Inspection弧形联轴器检查
I.Curvic Coupling Inspection 弧形联轴器检查NOTE: Nomenclature for curvic coupling is provided in Figure 320.注：图 320 中提供了弧形联轴器的命名。(1) Inspect components with curvic ...
SECTION IV – REPAIR 4. 修理铝制零件-E.Method No. 404E:轻微腐蚀修复
4. Repairing Aluminum Parts 修理铝制零件E.Method No. 404E: Minor Corrosion RepairMethod No. 404E:轻微腐蚀修复Remove minor corrosion from aluminum-alloy parts as follows:按如下步骤...
SECTION IV – REPAIR 7-更换钢丝螺套、螺柱、衬套、销钉和螺母板-I.Method No. 407I:松动、磨损或损坏的螺母板（铆接式）更换
7.Replacing Inserts, Studs, Bushings, Pins and Nutplates更换钢丝螺套、螺柱、衬套、销钉和螺母板I.Method No. 407I: Loose, Worn or Damaged Nutplate (Riveted) ReplacementMethod No. 407...
Honeywell-FITS AND CLEARANCES配合与间隙
配合与间隙FITS AND CLEARANCES Torque Values 扭矩值 (1) Tighten nuts, bolts, screws, and tube fittings to the standard torque unless specified differently. Refer to FAA Manual FAA-H...
2790583 COWL ANTI-ICE 3 1/2 INCH CONTROL VALVE ASSEMBLY
3-1/2英寸防冰控制活门组件 一、名称 COWL ANTI-ICE 3 1/2 INCH CONTROL VALVE ASSEMBLY 3-1/2英寸防冰控制活门组件 二、件号 2790583-104~-108,-105C,S312T001-4,-6,-7,-8 三、章节号 30-20-01...
Sealing Compounds
Sealing Compounds 密封化合物 Certain areas of all aircraft are sealed to withstand pressurization by air, to prevent leakage of fuel, to prevent passage of fumes, or to prevent cor...
SOPM20-11-03电气终端和电气连接区的修理
电气终端和电气连接区的修理REPAIR OF ELECTRICAL TERMINATIONS AND ELECTRICAL BONDING AREAS 1. INTRODUCTION 介绍 A.The data in this subject comes from Boeing Process Specifications...
千分尺读数及使用方法
千分尺读数及使用方法 在机械领域，针对微米(um)级别的高精度零件测量与检测，传统的游标卡尺往往难以达到所需的精确度。此时，千分尺成为了不可或缺的精密测量工具。 01 外径千分尺及其...
飞机维修工程管理-工程技术管理
一、规章赋予工程技术部门的职责 CCAR121.371及AC-121-FS-075对维修系统中工程技术部门的机构设置、职责及人员资质都有详细要求，具体如下： 一个工程技术部门，负...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-D.Method No.403D：金属喷涂修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用D.Method No. 403D: Metal Spray RepairMethod No.403D：金属喷涂修复NOTE: Electric Arc Spray and...
1.4 Joint Aircraft SystemComponent (JASC) Code联合飞机系统/组件(JASC)代码
Joint Aircraft SystemComponent (JASC) Code联合飞机系统/组件(JASC)代码The Joint Aircraft System/Component (JASC) Code table is a modified version of the Air Transport Association of...
6763 Series Valve bleed HP
高压引气活门（HPV） 一、名称 Valve bleed HP 高压引气活门（HPV） 二、件号 6763 Series 三、章节号 36-11-26 四、适用机型 A330 五、系统 36 PNEUMATIC 气源 六、安装位置 发动机短舱 七...
HOEYWELL SECTION II – CLEANING 清洁（四）
4. Alternate Cleaners 替代清洁剂 A. General 通用 (1) Alternate cleaners may be used in lieu of those specified in Method No. 202A and Method No. 202E. Previously approved alternate...
飞机的防火部位 Fire Protection Parts of Aircraft【转】
飞机的防火部位Fire Protection Parts of Aircraft 飞机上需防火的区域主要包括发动机、APU、货舱、起落架舱、电子设备舱、驾驶舱、客舱及机翼和燃油箱等其它危险区域。飞机常见的防火系统如图1...
