SECTION IV – REPAIR 4. 修理铝制零件-D.Method No. 404D:燃油和滑油泵铝制壳体表面修复
4. Repairing Aluminum Parts 修理铝制零件D.Method No. 404D: Fuel and Oil Pump Aluminum Housing Surface RepairMethod No. 404D:燃油和滑油泵铝制壳体表面修复Repair worn and/or damaged s...
SECTION IV – REPAIR 7-更换钢丝螺套、螺柱、衬套、销钉和螺母板-G.Method No. 407G:松动、磨损或损坏的销钉（铝或镁零件）更换
7.Replacing Inserts, Studs, Bushings, Pins and Nutplates更换钢丝螺套、螺柱、衬套、销钉和螺母板G.Method No. 407G: Loose, Worn, or Damaged Pins (Aluminum or Magnesium Parts) Replacem...
802170 HIGH PRESSURE SHUTOFF VALVE
高压关断活门 一、名称HIGH PRESSURE SHUTOFF VALVE高压关断活门二、件号802170-1~-12三、章节号36-12-14四、适用机型B747-400/B767五、系统36 PNEUMATIC气源六、安装位置发动机七、部件原理1. ...
341F SOLENOID THERMOSTAT
一、名称SOLENOID THERMOSTAT电磁恒温器二、件号341F010000,341F020000三、章节号36-11-10四、适用机型A319/A320五、系统36-PNEUMATIC气源六、安装位置发动机吊架七、部件原理Operation (Fig FU...
SECTION IV – REPAIR 3.防护涂料及电镀的修复与应用-J.Method No. 403J: 选择性电镀
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用J.Method No. 403J: Selective ElectroplatingMethod No. 403J:选择性电镀NOTE: If parts out of ap...
SECTION IV – REPAIR 6 -修理镁零件-B.Method No. 406B:镁合金零件严重损坏修复
6.Repairing Magnesium Parts修理镁零件B.Method No. 406B: Magnesium-Alloy Parts Heavy Damage RepairMethod No. 406B:镁合金零件严重损坏修复Repair minor damage to magnesium-alloy parts ...
紧固件扭矩（力矩）-扭矩与扭矩扳手-手柄加长是否影响力矩？？-开口销孔对齐
Torque and Torque Wrenches 扭矩与扭矩扳手As the speed of an aircraft increases, each structural member becomes more highly stressed. It is therefore extremely important that each m...
6713D HP REGULATING VALVE
一、名称HP REGULATING VALVE高压调节活门（HPV）二、件号6713D010000,6713D020000,6713D040000,Amdt A,6713D050000,Amdt A,6713D060000,Amdt A,6713D070000,Amdt A三、章节号36-11-51四、适用...
SECTION III – INSPECTION 1. Standard Inspection Practices -E. 轴承检查
E. Bearing Inspection轴承检查(1) Separable Bearings:可分解的轴承。Table 301. Separable Bearing Defect Definitions表301 可分解轴承缺陷的定义Term项目Definition (Description of Defect...
773289 HEAL THY CHECK NOT PASSSED
六、飞机系统中关于故障信息的分析健康测试如下：AMM中健康测试，对HPC的压力开关和压差开关转换进行测试，并给和HPSOV一起测试，对压力和电磁铁进行测试。详情如下：
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-O. Method No. 403O:镁的化学膜修补
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用O.Method No. 403O: Chemical Film Touch-Up of MagnesiumMethod No. 403O:镁的化学膜修补(1) Remov...
何为飞机的A检、B检、C检和D检？
飞机的A检、B检、C检和D检是根据飞行时间或起落次数对飞机进行的定期检查等级。A检：A检是最基础的检查，其飞行间隔通常较短，例如家用波音737的A检通常设置为200小时。A检不需要专门的飞行日停...
SECTION IV – ASSEMBLY 1-通用组装程序
1. General Assembly Practices 通用组装程序A. Protecting Unit During Assembly组装过程中的部件防护Maintain fits and clearances as specified in applicable manual for unit in work. Exe...
防火系统 Fire Protection System【转】
防火系统组成 Composition of Fire Protection System 飞机的防火系统由火警探测系统和灭火系统两大部分组成。防火系统平常不工作，一旦发生火险必须迅速扑灭火源，因此，飞机的防火系统需要定...
SECTION III – INSPECTION 1. Standard Inspection Practices -I.弧形联轴器检查
I.Curvic Coupling Inspection 弧形联轴器检查NOTE: Nomenclature for curvic coupling is provided in Figure 320.注：图 320 中提供了弧形联轴器的命名。(1) Inspect components with curvic ...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-G.Method No. 403G:耐磨涂层表面磨损修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用G.Method No. 403G: Abradable Coating Surface Wear RepairMethod No. 403G:耐磨涂层表面磨损修复N...
