分类
子分类
排序
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-H.Method No. 403H:镀银修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用H.Method No. 403H: Silver Plating RepairMethod No. 403H:镀银修复NOTE: If the type of silver p...
2025-09-14
SECTION IV – ASSEMBLY 3-锥形密封件
3.Conical Seal锥形密封件NOTE: Conical seals are used at specific locations during engine production to preclude leakage. However, conical seals may be used at any flared tubing fit...
2025-11-22
第八章 高频插头和指示系统插头/座的装配
详解航空高频同轴电缆插头/座与指示系统信号线插头/座的装配标准工艺。涵盖KINGS带保护同轴电缆插头（含小号型）、双层同轴电缆插头、K-LOC同轴电缆插头的制作与安装程序，以及指示系统防护插钉...
2026-07-09
SOPM20-20-01磁粉探伤
磁粉探伤MAGNETIC PARTICLE INSPECTION 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing process specification BAC5424. The data about magnetic rubber comes from MIL...
2025-03-07
SOPM20-42-03镀硬铬
镀硬铬HARD CHROME PLATING 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5709. Access to the Boeing Process Specifications is availa...
2025-03-14
SOPM20-50-15浇铸非金属垫片的安装
浇铸非金属垫片的安装INSTALLATION OF CASTABLE NON-METAL SHIMS 1. INTRODUCTION 介绍 A. This data in this subject comes from Boeing Process Document D042T613. The airline has or can g...
2025-03-30
HOEYWELL SECTION II – CLEANING 4. 替代清洁剂
4. Alternate Cleaners 替代清洁剂A. General通用(1) Alternate cleaners may be used in lieu of those specified in Method No. 202A and Method No. 202E. Previously approved alternates a...
2025-04-07
SECTION IV – REPAIR 7-更换钢丝螺套、螺柱、衬套、销钉和螺母板-B.Method No.407B：更换松动或损坏的螺纹钢丝螺套（铝或镁零件）
7.Replacing Inserts, Studs, Bushings, Pins and Nutplates更换钢丝螺套、螺柱、衬套、销钉和螺母板B.Method No. 407B: Loose or Damaged Thread Inserts (Aluminum or Magnesium Parts) Repla...
2025-11-03
紧固件扭矩（力矩）-扭矩与扭矩扳手-手柄加长是否影响力矩？？-开口销孔对齐
Torque and Torque Wrenches 扭矩与扭矩扳手As the speed of an aircraft increases, each structural member becomes more highly stressed. It is therefore extremely important that each m...
2025-11-09
