A330-30防冰防雨【系统原理】
A330-200/300TECHNICAL TRAINING MANUALICE AND RAIN PROTECTION技术培训手册防冰防雨 CONTENTS 目录 ICE AND RAIN PROTECTION Ice & Rain Protection Line MAINT Briefing (2) 防冰和防雨...
SPM 20-90-01波音氧气系统部件清洁工艺(Cobham)
Cleaning Process for Boeing Oxygen System Components-Standard Practice Manual丨波音氧气系统部件清洁工艺-标准操作手册 TABLE OF CONTENTS CLEANING PROCESS 1. Scope 2. General Recommen...
SECTION IV – REPAIR 4. 修理铝制零件-E.Method No. 404E:轻微腐蚀修复
4. Repairing Aluminum Parts 修理铝制零件E.Method No. 404E: Minor Corrosion RepairMethod No. 404E:轻微腐蚀修复Remove minor corrosion from aluminum-alloy parts as follows:按如下步骤...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-D.Method No.403D：金属喷涂修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用D.Method No. 403D: Metal Spray RepairMethod No.403D：金属喷涂修复NOTE: Electric Arc Spray and...
SECTION IV – REPAIR 7-更换钢丝螺套、螺柱、衬套、销钉和螺母板-G.Method No. 407G:松动、磨损或损坏的销钉（铝或镁零件）更换
7.Replacing Inserts, Studs, Bushings, Pins and Nutplates更换钢丝螺套、螺柱、衬套、销钉和螺母板G.Method No. 407G: Loose, Worn, or Damaged Pins (Aluminum or Magnesium Parts) Replacem...
SECTION IV – ASSEMBLY 8-Marman卡箍（联轴器）安装
8.Marman Clamp (Coupling) InstallationMarman卡箍（联轴器）安装(1) Position clamp over mating component flanges as described in applicable manual.参照适用手册说明，将卡箍定位于配合...
清洁 二 CLEANING
4. Abrasive Cleaning Procedures 磨料清洗程序 A. Deleted. 已删除。 B. Task 1: Dry Abrasive Blast 任务1：干式磨料喷砂 CAUTION: DO NOT USE DRY ABRASIVE BLAST ON SURFACES WITH 63 RA OR...
电气性能之绝缘电阻、介电强度、电阻、搭接电阻的介绍
电气性能之绝缘电阻、电阻、搭接电阻、介电强度 我们在做机械部件电气测试时，CMM要求测试的电气性能主要有：绝缘电阻、电阻、电连接、介电强度等，下面为大家简单讲解它们的具体的功能及区...
10101000 WASTE DRAIN VALVE ASSEMBLY【部件介绍】
排污活门10101000系列 一、名称 WASTE DRAIN VALVE ASSEMBLY 排污活门 二、件号 10101000CA,10101000C-A,10101000CG,10101000C-G,10101000CH,10101000C-H,10101000CJ,10101000C-J,10101000CA1,1...
3215618 NOSE COWLANTI-ICE VALVE
前整流罩防冰活门 一、名称NOSE COWLANTI-ICE VALVE前整流罩防冰活门二、件号3215618-2~-5三、章节号30-20-05四、适用机型B737-NG五、系统30 ICE AND RAIN PROTECTION防冰防雨六、安装位置发动...
A320-浅谈发动机引气压力波动
浅谈发动机引气压力波动 Discussion on Engine Bleed Pressure Fluctuation 原理分析 Principle analysis 引气原理图 pneumatic system-schematic 之前TSM上有两种发动机引气波动排故程序...
HOEYWELL SECTION II – CLEANING 2. 清洁溶液的配制
2. Preparation of Cleaning Solutions 清洁溶液的配制WARNING: SOLUTIONS USED FOR CLEANING ARE HAZARDOUS. AVOID INHALING FUMES, DUST, OR MIST. AVOID CONTACT WITH SKIN. AFTER PREPARATI...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-O. Method No. 403O:镁的化学膜修补
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用O.Method No. 403O: Chemical Film Touch-Up of MagnesiumMethod No. 403O:镁的化学膜修补(1) Remov...
紧固件扭矩（力矩）-扭矩与扭矩扳手-手柄加长是否影响力矩？？-开口销孔对齐
Torque and Torque Wrenches 扭矩与扭矩扳手As the speed of an aircraft increases, each structural member becomes more highly stressed. It is therefore extremely important that each m...
A320-36气源【系统原理】
A320TECHNICAL TRAINING MANUAL-PNEUMATIC技术培训手册-气动 PNEUMATIC SYSTEM COMPONENT LOCATION (2) SYSTEM OVERVIEW The Pneumatic system is used to supply High Pressure (HP) air fo...
