HOEYWELL SECTION II – CLEANING 2. 清洁溶液的配制
2. Preparation of Cleaning Solutions 清洁溶液的配制WARNING: SOLUTIONS USED FOR CLEANING ARE HAZARDOUS. AVOID INHALING FUMES, DUST, OR MIST. AVOID CONTACT WITH SKIN. AFTER PREPARATI...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-O. Method No. 403O:镁的化学膜修补
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用O.Method No. 403O: Chemical Film Touch-Up of MagnesiumMethod No. 403O:镁的化学膜修补(1) Remov...
飞机维修工程管理-适航限制项目(AWL)
适航限制项目(AWL)背景及定义：CCAR/FAR 25.571 结构的损伤容限和疲劳评定中要求，(3) 根据本条要求的评定，必须制订为预防灾难性破坏所必须的检查工作或其它程序，并必须将其载入第25.1529条...
6763 Series Valve bleed HP
高压引气活门（HPV） 一、名称 Valve bleed HP 高压引气活门（HPV） 二、件号 6763 Series 三、章节号 36-11-26 四、适用机型 A330 五、系统 36 PNEUMATIC 气源 六、安装位置 发动机短舱 七...
HOEYWELL SECTION II – CLEANING 清洁（四）
4. Alternate Cleaners 替代清洁剂 A. General 通用 (1) Alternate cleaners may be used in lieu of those specified in Method No. 202A and Method No. 202E. Previously approved alternate...
空调和增压系统（Air conditioning and Pressurization System）【转】
空调和增压系统Air conditioning and Pressurization System飞机增压座舱的要求Requirements for Aircraft Pressurized Cabin（1）座舱温度要求Cabin temperature requirements根据人体生理卫生...
SECTION III – INSPECTION 检查（六）-弧形联轴器检查
I.Curvic Coupling Inspection 弧形联轴器检查NOTE: Nomenclature for curvic coupling is provided in Figure 320.注：图 320 中提供了弧形联轴器的命名。(1) Inspect components with curvic ...
SOPM20-00-00 介绍
介绍INTRODUCTION The instructions in this manual tell how to do standard shop procedures during maintenance functions from simple checks and replacement to complete shop-type repai...
SECTION IV – REPAIR 修理（三）-E.Method No. 403E: Dry-film Lubricant Repair
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用E.Method No. 403E: Dry-film Lubricant RepairMethod No. 403E：干膜润滑剂修复Dry-film lubricant...
SECTION III – INSPECTION 1. Standard Inspection Practices -K.过滤器气泡点检查
K.Bubble Point Check for Filters过滤器气泡点检查(1) Perform bubble point test on filter in accordance with MIL-F-5504B.根据MIL-F-5504B对过滤器进行气泡点测试。(a) The largest pore s...
飞机维修工程管理-维修思想
按照什么思想来制订航空器的预定维修大纲并对它进行管理，是多年来人们一直研究的中心问题。纵观近百年的航空维修发展史，维修思想经历了由故障维修发展为预防性维修，通过不断的研究、进而完善...
SECTION IV – REPAIR 7-更换钢丝螺套、螺柱、衬套、销钉和螺母板-J.Method No. 407J: 松动、磨损或损坏的螺母板（焊接式）更换
7.Replacing Inserts, Studs, Bushings, Pins and Nutplates更换钢丝螺套、螺柱、衬套、销钉和螺母板 J.Method No. 407J: Loose, Worn or Damaged Nutplate (Welded) ReplacementMethod No. 40...
E61751 HALON Pressure Reducer【部件介绍】
HALON减压器 一、名称 HALON Pressure Reducer HALON减压器 二、件号 D41428-SERIES/D41552-SERIES/E61751-00-0001/E61751-00-0002/E61751-00-0003/E62691-00 三、章节号 26-20-10 四、适用机型...
Shock Absorber Cord减震绳
Shock Absorber Cord减震绳 Shock absorber cord is made from natural rubber strands encased in a braided cover of woven cotton cords treated to resist oxidation and wear. Great tensi...
6774G BLEED VALVE（PRV）
引气活门（PRV） 一、名称 BLEED VALVE 引气活门（PRV） 二、件号 6774F010000,6774F010000 Amdt A,6774F010000 Amdt AB,6774G010000,6774G010000 Amdt A 三、章节号 36-11-28 四、适用机型 A32...
Seals,Packings,Backup Rings,Gaskets,Wipers
Seals 密封 Seals are used to prevent fluid from passing a certain point, as well as to keep air and dirt out of the system in which they are used. The increased use of hydraulics a...
SOPM20-11-02电连接器的修理
电连接器的修理REPAIR OF ELECTRICAL CONNECTORS 1.INTRODUCTION 介绍 A.The following information is based on Boeing process specification BAC 5162 for assembly of electrical connec...
SPM 20-90-01波音氧气系统部件清洁工艺(Cobham)
Cleaning Process for Boeing Oxygen System Components-Standard Practice Manual丨波音氧气系统部件清洁工艺-标准操作手册 TABLE OF CONTENTS CLEANING PROCESS 1. Scope 2. General Recommen...
SECTION IV – REPAIR 修理（三）-J.Method No. 403J: Selective Electroplating
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用J.Method No. 403J: Selective ElectroplatingMethod No. 403J:选择性电镀NOTE: If parts out of ap...
SECTION IV – REPAIR 3. 防护涂料及电镀的修复与应用-E.Method No. 403E：干膜润滑剂修复
3. Repair and Application of Protective Coatings and Plating 防护涂料及电镀的修复与应用E.Method No. 403E: Dry-film Lubricant RepairMethod No. 403E：干膜润滑剂修复Dry-film lubricant...
