分类
子分类
排序
SOPM20-10-06导电涂层的修理
导电涂层的修理REPAIR OF CONDUCTIVE COATINGS 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5837 for preparation of exterior plastic sur...
紧固件扭矩(力矩)-扭矩与扭矩扳手-手柄加长是否影响力矩??-开口销孔对齐
Torque and Torque Wrenches 扭矩与扭矩扳手As the speed of an aircraft increases, each structural member becomes more highly stressed. It is therefore extremely important that each m...
SOPM20-10-27激光沉积钛
激光沉积钛LASER DEPOSITED TITANIUM 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Material Specification BMS 7-361 for laser deposition of titanium. Access t...
SOPM20-20-01磁粉探伤
磁粉探伤MAGNETIC PARTICLE INSPECTION 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing process specification BAC5424. The data about magnetic rubber comes from MIL...
HOEYWELL SECTION II – CLEANING 4. 替代清洁剂
4. Alternate Cleaners 替代清洁剂A. General通用(1) Alternate cleaners may be used in lieu of those specified in Method No. 202A and Method No. 202E. Previously approved alternates a...
SOPM20-44-02临时保护涂层
临时保护涂层TEMPORARY PROTECTIVE COATINGS 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5034 which superseded BAC5835. The airline has...
SOPM20-41-02耐化学和耐溶剂饰面的应用
耐化学和耐溶剂饰面的应用APPLICATION OF CHEMICAL AND SOLVENT RESISTANT FINISHES 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5736 a...
SOPM20-30-99结构粘接前复合材料最终清洗的溶剂(99系列)
结构粘接前复合材料最终清洗的溶剂(99系列)SOLVENTS FOR FINAL CLEANING OF COMPOSITES BEFORE STRUCTURAL BONDING (SERIES 99) 1. GENERAL 通用 A. This subject contains a list of solvent...
SOPM20-50-20如何制作和安装树脂粘合层叠垫片和固体填充物
如何制作和安装树脂粘合层叠垫片和固体填充物HOW TO MAKE AND INSTALL RESIN BOND LAMINATED SHIMS AND SOLID FILLERS 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Pr...
HOEYWELL INTRODUCTION 介绍
INTRODUCTION介绍 1. General 通用 Information provided in this manual pertains to overhaul and repair processing for parts manufactured by Honeywell Inc., Phoenix, Arizona. 本手册提...
SOPM20-30-81所有有机涂料的一般清洗用溶剂(81系列)
所有有机涂料的一般清洗用溶剂(81系列)SOLVENTS FOR GENERAL CLEANING OF ALL ORGANIC COATINGS (SERIES 81) 1. GENERAL 通用 A. This subject contains a list of solvents for general c...
Sealing Compounds
Sealing Compounds 密封化合物 Certain areas of all aircraft are sealed to withstand pressurization by air, to prevent leakage of fuel, to prevent passage of fumes, or to prevent cor...
Seals,Packings,Backup Rings,Gaskets,Wipers
Seals 密封 Seals are used to prevent fluid from passing a certain point, as well as to keep air and dirt out of the system in which they are used. The increased use of hydraulics a...
SECTION IV – REPAIR 11-焊接零件修理
Repairing Welded Parts 焊接零件修理 NOTE: Refer to applicable manual for unit for specialized welding. 注:特殊焊接操作请参阅设备适用手册。 A. Method No. 411A: Fusion Weld Repair o...
SECTION IV – ASSEMBLY 6 -保险丝安装与技术
6.Lockwire Installation and Techniques保险丝安装与技术A.General概述Appropriate diameter lockwire (specified in Aerospace Standard 567) is installed using the following techniques a...
SOPM20-30-92一般密封前的最终清洗用溶剂(92系列)
一般密封前的最终清洗用溶剂(92系列)SOLVENTS FOR FINAL CLEANING BEFORE GENERAL SEALING (SERIES 92) 1. GENERAL 通用 A. This subject contains a list of solvents for final clean...
SOPM20-42-04电镀用铝合金的制备
电镀用铝合金的制备PREPARATION OF ALUMINUM ALLOYS FOR ELECTROPLATING 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5714. The airline ha...
SOPM20-30-87喷涂前复合材料最终清洗的溶剂(87系列)
喷涂前复合材料最终清洗的溶剂(87系列)SOLVENTS FOR FINAL CLEANING OF COMPOSITES BEFORE PAINTING (SERIES 87) 1. GENERAL 通用 A. This subject contains a list of solvents for...
SOPM20-43-04电刷电镀、阳极氧化和电化学蚀刻
电刷电镀、阳极氧化和电化学蚀刻BRUSH PLATING, ANODIZING AND ELECTROCHEMICAL ETCHING 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC 5...
SOPM20-42-09电沉积镀镍
电沉积镀镍ELECTRODEPOSITED NICKEL PLATING 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5746 for electrodeposited nickel plating...





















