INTRODUCTION介绍 1. General 通用 Information provided in this manual pertains to overhaul and repair processing for parts manufactured by Honeywell Inc., Phoenix, Arizona. 本手册提...

热喷涂涂层的应用和表面处理APPLICATION AND FINISHING OF THERMAL SPRAY COATINGS   1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specifications BAC5851 a...

导电涂层的修理REPAIR OF CONDUCTIVE COATINGS 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5837 for preparation of exterior plastic sur...

钛的机械加工MACHINING OF TITANIUM 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5492, and Boeing Operators Handbook 6M59-553, 'Machini...

复合材料结构上表面密封的金属配件的拆除REMOVAL OF FAYING SURFACE SEALED METAL FITTINGS FROM COMPOSITE STRUCTURES 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing P...

SECTION I – DISASSEMBLY分解 TABLE OF CONTENTS 目录 SECTION 章节 1. Standard Disassembly Practices 标准分解操作 A. General 通用 B. Identification of Matched Parts and Sets 识别配合...

印刷电路组件和元件板组件的修理REPAIR OF PRINTED CIRCUIT ASSEMBLIES AND COMPONENT BOARD ASSEMBLIES   1. INTRODUCTION 介绍 A. The data in this subject comes from the Boeing Process ...

铜铍合金的机加工MACHINING OF COPPER BERYLLIUM ALLOYS   1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Process Specification BAC5648. The airline has a copy of ...

激光沉积钛LASER DEPOSITED TITANIUM   1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing Material Specification BMS 7-361 for laser deposition of titanium. Access t...

电连接器的修理REPAIR OF ELECTRICAL CONNECTORS   1.INTRODUCTION 介绍 A.The following information is based on Boeing process specification BAC 5162 for assembly of electrical connec...

电气终端和电气连接区的修理REPAIR OF ELECTRICAL TERMINATIONS AND ELECTRICAL BONDING AREAS   1. INTRODUCTION 介绍 A.The data in this subject comes from Boeing Process Specifications...

电气和电子元件标准维护说明ELECTRICAL AND ELECTRONIC COMPONENT STANDARD MAINTENANCE INSTRUCTIONS   1. INTRODUCTION 介绍 A. This subject gives general instructions for overhaul of a...

仪表盘电气模块通用信息INSTRUMENT PANEL ELECTRICAL MODULE GENERAL INFORMATION   1. INTRODUCTION 介绍 A. The airplane instrument panel contains electrical modules which have a basep...

缠绕导线电气连接的修理REPAIR OF WRAPPED WIRE ELECTRICAL CONNECTIONS   1. INTRODUCTION 介绍 A. A wrapped wire connection consists of a helix of continuous, solid, uninsulated wire ...

表面安装设备的拆除和更换REMOVAL AND REPLACEMENT OF SURFACE MOUNTED DEVICES 1. INTRODUCTION 介绍 A. The data in this subject comes from Boeing process specification BAC5128 (which s...

2. Preparation of Cleaning Solutions 清洁溶液的配制 WARNING: SOLUTIONS USED FOR CLEANING ARE HAZARDOUS. AVOID INHALING FUMES, DUST, OR MIST. AVOID CONTACT WITH SKIN. AFTER PREPARAT...

E. Bearing Inspection 轴承检查 (1) Separable Bearings: 可分解的轴承。 Table 301. Separable Bearing Defect Definitions 表301 可分解轴承缺陷的定义 Term 项目 Definition (Description o...

F. Gear and Spline Inspection 齿轮和花键检查 (1) Check gear and spline teeth as follows: 检查齿轮和花键齿，如下所示： (a) Perform visual check using a strong light and a minimum of...

Sealing Compounds 密封化合物 Certain areas of all aircraft are sealed to withstand pressurization by air, to prevent leakage of fuel, to prevent passage of fumes, or to prevent cor...

Seals 密封 Seals are used to prevent fluid from passing a certain point, as well as to keep air and dirt out of the system in which they are used. The increased use of hydraulics a...

G. Visual Inspection 目视检查 (1) General Information 通用信息 (a) Visual inspection involves viewing the part for general appearance in an effort to locate conditions, which cause...

H. Electrical Component Inspection 电气组件检查CAUTION: REFER TO APPLICABLE MANUAL PRIOR TO PERFORMING ANY ELECTRICAL CHECKS TO ENSURE THAT CHECKS WILL NOT DAMAGE EQUIPMENT.注意：...